- The Nitro key App no longer recognizes the device at all.
- I did not know there was a binary, I went back and installed it from the distro, successfully. No change in results. Still getting “no device present to all commands”.
- Yes, I did try plugging in/out, rebooting, several times.
- Yes, I also did try re-erasing, bu the erase command also gives “no device present”.
- Again I was only able to access the device with the erase command once, no longer.
Here is the verbose lsusb output of the device (bus/device updated since replug:
Bus 002 Device 003: ID 03eb:2ff1 Atmel Corp.
Couldn’t open device, some information will be missing
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 64
idVendor 0x03eb Atmel Corp.
idProduct 0x2ff1
bcdDevice 10.00
iManufacturer 1
iProduct 2
iSerial 3
bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 27
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 0
bmAttributes 0xc0
Self Powered
MaxPower 100mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 0
bInterfaceClass 254 Application Specific Interface
bInterfaceSubClass 1 Device Firmware Update
bInterfaceProtocol 2
iInterface 0
Device Firmware Upgrade Interface Descriptor:
bLength 9
bDescriptorType 33
bmAttributes 15
Will Detach
Manifestation Tolerant
Upload Supported
Download Supported
wDetachTimeout 0 milliseconds
wTransferSize 65535 bytes
bcdDFUVersion 1.01